Follow along as Jess Francisco shows you how to colorize Ranger Metallic White Texture Paste with Liquid Pearls™ to create this luminous thank you card.
Texture Paste Thank You Card by Jess Francisco
- Materials
- Instructions
Simon Hurley create. Photopolymer Stamp Set: Doodle Florals
Letter It™ Stencil: Treading Hearts
Simon Hurley Paste Tools Set
Ranger Metallic White Texture Paste
Ranger Liquid Pearls™: Succulent, Bahama Bay, Deep Water
Simon Hurley create. Stamping Blocks
Ranger Multi Medium Matte
Ranger Adhesive Foam Tape White
Ranger Anti-Static Pouch
Ranger Watermark Resist Ink
Super Fine Detail Embossing Powder White
Ranger Non-Stick Craft Sheet
Simon Hurley Stark White Cardstock
Other:
Black Cardstock
Heat Tool
Scissors
Paper Trimmer
Instructions
Step 1: Use the palette knife from the Paste Tools set to scoop out some White Metallic Texture Paste. Apply it to a craft sheet or non porous surface to be mixed. Add in some of the Liquid Pearls (Succulent) and mix them together with the palette knife until well combined.
Step 2: Place the Treading Hearts stencil over a piece of white cardstock measuring approximately 3.75” x 5”. Using the palette knife, spread the mixture through the stencil to cover the top third of the cardstock. Without moving the stencil, repeat steps one and two with Deep Water and Bahama Bay Liquid Pearls, applying each mixture to about a third of the cardstock.
Step 3: Carefully remove the stencil and set the cardstock aside to dry. Be sure to clean your stencil, craft sheet, and tools to ensure the paste is removed.
Step 4: Treat a piece of black cardstock with the anti-static pouch. Stamp the ‘thank you’ sentiment from Doodle Florals onto the black cardstock with Watermark Resist ink. Pour white embossing powder over the wet ink and tap off the excess. Melt the powder with a Heat Tool.
Step 5: Trim the sentiment with a paper trimmer. Apply foam tape to the back.
Step 6: Assemble the card. Attach the stenciled cardstock to a white A2 sized card base (4.25”x5.5”). Remove the backing from the foam tape and attach the sentiment to the card front. You’re done!