Make this colorful summer tag with Ranger Embossing Powders.
Summer Flower Tag By Debbie Tlach
- Materials
- Instructions
- Ranger Non-Stick Craft Sheet™
- Ranger Embossing Powders: Magenta, Pink, Green, Lime Green, Light Blue, Orange & Yellow
- Ranger Emboss It™ Ink Pad
- Dina Wakley Media Stencil: Plastic Canvas
- Ranger Heat it™ Craft Tool
- Ranger Glossy Accents™
- Tim Holtz Alterations by Sizzix - Vagabond, Base Tray, Cutting Pads, Movers and Shapers Mini Tattered Florals & Mini Tattered Leaves, & Mini Butterflies
- Studio 490 Wendy Vecchi by Stampers Anonymous - Art Parts Clearly for Art
- Metal Cap/Lid (I used a Distress Glitter Lid), Ribbon, Pencil
Instructions
- Die cut shapes from Shrink Plastic and Clearly for Art. Apply Embossing Ink to one side of the Clearly for Art 9 petal flower. Working over scrap paper, sprinkle a tiny bit of Orange Embossing Powder randomly over the flower. Put excess powder back in jar.
- Working over scrap paper, pour Yellow Embossing Powder over the flower. Tap off the excess and return to jar.Working over a Craft Sheet, melt the Embossing Powder with a Craft Tool. While the Flower is warm, carefully put it inside a metal cap/lid and press down on the center of the flower with the tip of a pencil. If needed, warm the flower with Craft Tool and push again to curve the petals. Let cool. Repeat using Magenta & Orange Embossing Powders with The Clearly for Art 6 petal flower. Repeat with the Light Blue & Magenta Embossing Powder and Clearly for Art butterfly shape. Repeat with the Green & Lime Green Embossing Powder with the Clearly for Art Leaf shapes. (Do not curve these shapes. They will be the stem & leaves of the flower).
- Repeat with Magenta and Pink Embossing Powder on Shrink Plastic 6 petal flower.Repeat with Yellow and Pink Embossing Powder on the Shrink Plastic 9 petal flower. Repeat with Magenta & Light Blue Embossing Powder on Shrink Plastic butterfly shape.
- Place the Dina Wakley Plastic Canvas Stencil over the tag. Use the Embossing Pad and tap the ink through the stencil around the edges of the tag. Lift the stencil off and pour Light Blue Embossing Powder onto the inked design over a piece of scrap paper. Return excess to jar.
- Melt the embossing powder with the Heat Tool. Let cool.
- Tie a ribbon through the hole in the tag. Layer and adhere shapes to tag with Glossy Accents.
Related Posts
Halloween Treat Bags by Lauren Bergold
Halloween is creeping closer, and what better way to celebrate than with these frightfully fun treat bags?...
Read More
Ranger Crackle Texture Paste Halloween Card by Kimberly Boliver
Celebrate Halloween with this cute bat card tutorial by Kimberly Boliver! Featuring Ranger Crackle Texture Paste, it creates a unique,...
Read More